PAVER INSTALLATION
IN UNIVERSITY PARK.
University Park's dense lots, mature trees, and 1930s-60s homes require careful demolition, root-zone excavation, and materials that match the architectural period.
Period-matched brick and stone walkways, small estate patios, and driveway restorations near SMU and Volk Estates.
Colonial revival, Tudor, Georgian, transitional new-build.
- • Volk Estates
- • SMU area
- • Caruth Homeplace
WHAT WE BUILD
IN UNIVERSITY PARK.
Walkways & Entries in University Park
Front paths, side yards, and courtyards that hold their line.
$16–$30 / sq ft installedView Walkways details →02Paver Driveways in University Park
Load-rated driveway systems built to DOT sub-base standards.
$20–$38 / sq ft installedView Driveways details →01Paver Patios in University Park
Outdoor living surfaces engineered for Texas heat and clay.
$16–$30 / sq ft installedView Patios details →05Paver Repair & Restoration in University Park
Level, re-sand, seal, and replace — restore what already exists.
$6–$15 / sq ft depending on scopeView Repair details →Why University Park paver work needs a real engineered base
Every paver installation in University Park, TX starts under the surface. North Texas clay in Dallas County expands and contracts with moisture — sometimes 3–4 inches per season — and pavers set on inadequate base ride that soil movement until they crack, sink, or heave.
We install every University Park project with 8–12 inches of compacted structural aggregate, geotextile separation fabric, edge restraints, and polymeric sand joints. That's the same spec regardless of whether we're building a $6,000 walkway in Volk Estates or a $60,000 estate driveway in Caruth Homeplace.
Paverston is a Belgard authorized installer serving University Park and the wider Dallas County area. Every project carries our workmanship warranty on top of the Belgard manufacturer warranty.
University Park paver FAQs
Can you match the original brick or stone on my University Park home?
Yes — we source period-appropriate clay brick, tumbled concrete pavers, and natural stone that reads with the architecture. Matching material and pattern to a 1940s Tudor or 1960s ranch is a design decision we take seriously.
How much does paver installation cost in DFW?
Preliminary DFW ranges: patios $16–$30/sq ft, driveways $20–$38/sq ft, pool decks $20–$38/sq ft, walkways $16–$30/sq ft, repair $6–$15/sq ft installed. Outdoor kitchens $10,000–$50,000+, fire pits $4,000–$20,000+, turf $11–$20/sq ft, lighting $2,500–$15,000+. Final pricing depends on material, demolition, base prep, drainage, and access. Upload photos for a project-specific range.
Why do pavers sink or become uneven in North Texas?
Almost always inadequate base preparation. North Texas clay expands and contracts violently with moisture; without 8–12 inches of compacted aggregate base and proper drainage, pavers settle within a few years.
Get a University Park paver estimate today.
Upload photos for a preliminary range or call Mark to schedule an on-site walk-through.