PAVER INSTALLATION
IN RICHARDSON.
Richardson's Canyon Creek and Prairie Creek homes date to the 1970s-80s — original driveways and patios are at end of life and paver replacements make dramatic curb-appeal improvements.
1970s-80s home driveway and patio replacements across Canyon Creek, Prairie Creek, and The Reservation.
Mid-century modern, ranch, contemporary remodel.
- • Canyon Creek
- • Cottonwood Heights
- • Prairie Creek
- • The Reservation
WHAT WE BUILD
IN RICHARDSON.
Paver Driveways in Richardson
Load-rated driveway systems built to DOT sub-base standards.
$20–$38 / sq ft installedView Driveways details →01Paver Patios in Richardson
Outdoor living surfaces engineered for Texas heat and clay.
$16–$30 / sq ft installedView Patios details →04Walkways & Entries in Richardson
Front paths, side yards, and courtyards that hold their line.
$16–$30 / sq ft installedView Walkways details →05Paver Repair & Restoration in Richardson
Level, re-sand, seal, and replace — restore what already exists.
$6–$15 / sq ft depending on scopeView Repair details →Why Richardson paver work needs a real engineered base
Every paver installation in Richardson, TX starts under the surface. North Texas clay in Dallas County expands and contracts with moisture — sometimes 3–4 inches per season — and pavers set on inadequate base ride that soil movement until they crack, sink, or heave.
We install every Richardson project with 8–12 inches of compacted structural aggregate, geotextile separation fabric, edge restraints, and polymeric sand joints. That's the same spec regardless of whether we're building a $6,000 walkway in Canyon Creek or a $60,000 estate driveway in The Reservation.
Paverston is a Belgard authorized installer serving Richardson and the wider Dallas County area. Every project carries our workmanship warranty on top of the Belgard manufacturer warranty.
Richardson paver FAQs
Should I replace my original 1970s Richardson driveway with pavers?
If the concrete is spalling, sinking, or cracked past 1/2 inch — yes. A paver driveway is a permanent solution, individual units are repairable, and it will outlast a fresh concrete pour. Richardson driveways benefit especially because the original slabs are 40+ years old and often installed without a proper sub-base.
How much does paver installation cost in DFW?
Preliminary DFW ranges: patios $16–$30/sq ft, driveways $20–$38/sq ft, pool decks $20–$38/sq ft, walkways $16–$30/sq ft, repair $6–$15/sq ft installed. Outdoor kitchens $10,000–$50,000+, fire pits $4,000–$20,000+, turf $11–$20/sq ft, lighting $2,500–$15,000+. Final pricing depends on material, demolition, base prep, drainage, and access. Upload photos for a project-specific range.
Why do pavers sink or become uneven in North Texas?
Almost always inadequate base preparation. North Texas clay expands and contracts violently with moisture; without 8–12 inches of compacted aggregate base and proper drainage, pavers settle within a few years.
Get a Richardson paver estimate today.
Upload photos for a preliminary range or call Mark to schedule an on-site walk-through.